LE MANS ULTIMATE · GUIDE
Why your Le Mans Ultimate setup stops working after a patch
A Le Mans Ultimate setup stores clicks, not values. If a patch changes a car's ranges, the same click gives something else. How to check it in two minutes.

A Le Mans Ultimate update comes out, you load your usual setup and the car no longer feels the same. It is not in your head: it comes down to how the game stores setups.
A setup stores clicks, not values
Open any setup (.svm) in Notepad. Each setting is a line like this:
The number before the slashes is the click: the setting's position in its list. What comes after is a comment with the value that click gave when it was saved. The game loads the click.
What a patch does
- It changes a setting's range. If brake bias starts at another value or moves in different steps, click 17 is no longer 52.3%.
- It removes or adds positions. If a wing gets fewer positions, a high click can fall out of range.
- It changes the car. With a Balance of Performance (BoP) or tyre change, the same setup behaves differently even if every click gives the same value.
How to check it in two minutes
- Open the .svm in Notepad and note the comment of three or four settings that matter: wing, brake bias, ride height and traction control.
- Load the setup in the garage and look at those settings.
- If what you see does not match the comment, that setup was made on another version: rebuild it in the garage or find one for your version.
